Cable Identifier™ Extra Power supply
This extra Power supply does not come with LEDs that are needed for network port identification. Please check out our "Cable Identifier Combo Pack™" PART # 102440.
The original Cable Identifier is available exclusively at CableSupply.com. It is a time saving tool that can cut down time wasted on locating cables on a patch panel by eliminating the need to tone & probe and the "bleed over" mistakes with tone. Simply load the patch panel with Cable Identifier LEDs then plug the power supply into keystone jacks throughout a newly installed job site.
The most efficient way to identify cables on a patch panel is CableSupply.com's original product: The Cable Identifier. The Cable Identifier is plugged into a jack and sends a signal to the patch panel. Instead of using a toner and checking every port one by one for a tone on the opposite end, where all the cables have already been punched down onto a patch panel, RJ45 LEDs are plugged into every port on the panel. The correlating port on the panel will light up immediately letting the technician know in a second which cable he is toning. The note can be made on a floor plan and then later, once all the cables have been identified, someone can go to each face plate and properly label each location. The Cable Identifier makes identifying and labeling cables so time efficient and easy that even the most novice cabler or technician could easily utilize it on a job site to save time, therefore saving money.
Eliminate the need to tone & probe
- Locate the correct port accurately and quickly
- Save money and time by purchasing this LED lights and Cable Identifier combo together right now
- Operates on two AA batteries (not included)
- See the video below for a tutorial
For the "Combo Pack" Red LED and Power Supply (TM) use part # 102440
For LED's click here: Red replacement LED Lights for Cable Identifier